If you click the “Reply” button you’ll see the “Attachments and other options” link. If the length of the output exceeds the forum’s 9000 character limit, save it in a txt file and post it here as an attachment.
#Lg flash tool serial code#
Paste the error messages in a reply here USING CODE TAGS ( button on the forum toolbar).After the compilation fails you’ll see a button on the right side of the orange bar “Copy error messages”.File > Preferences > Show verbose output during: > compilation (check) > OK.PinMode(WIFI_LED, OUTPUT) //define pinmodesĭigitalWrite(WIFI_LED, LOW) //Blink the light till connected to WiFiįirebase.begin(FIREBASE_HOST, FIREBASE_AUTH) //connect to Databaseįloat t = 0, h = 0, hp = 0, inches = 0, cm = 0, offset = 1.8 Long microsecondsToCentimeters(float microseconds)
Long microsecondsToInches(float microseconds) #define FIREBASE_AUTH "secret" //database secret #define FIREBASE_HOST "some_firebase_host" //link of api #define WIFI_LED D5 //connect a led to any of the gpio pins of the board and replace pin_number with it eg.
#Lg flash tool serial password#
#define WIFI_PASSWORD "1234" //replace PWD with your wifi password #define WIFI_SSID "wifi001" //replace SSID with your wifi username I have an issue uploading the sketch code from my arduino to Nondemcu v3…īasically, the code says to take data from the sensor and send it to the firebase but I have this error I’m not sure why is doesn’t work.